The PIONEER ONE® E3M - Metered Filtration Delivery System is the ultimate solution for clean and healthy drinking water. With its unique metered filtration technology, this system ensures safe drinking water at every tap in your home. No more worries about harmful contaminants or chemicals!

Designed to be easy to install, the PIONEER ONE® E3M brings convenience and peace of mind to your water filtration needs. Say goodbye to bacteria, parasites, and viruses that can compromise your health. This system removes all of them, guaranteeing that every sip you take is pure and refreshing.

What sets the PIONEER ONE® E3M apart is its environmentally-friendly approach. Say goodbye to chemicals and say hello to a greener alternative. Not only will you enjoy cleaner water, but you’ll also be making a positive impact on the planet.

Key Features:

• Easy installation process
• Chemical-free filtration for an eco-friendly solution

And that’s not all! The PIONEER ONE® E3M has undergone rigorous testing and has been third-party certified to meet NSF/ANSI standards. It successfully removes chemicals like PFOA/PFOS, reduces lead, and eliminates cysts. You can trust that this system will deliver on its promises.

Specifications:

• Tested and certified to NSF/ANSI P473 standard for PFOA/PFOS
• Tested and certified to NSF/ANSI 53 standard for lead and cyst reduction

Invest in the PIONEER ONE® E3M - Metered Filtration Delivery System and enjoy the peace of mind that comes with clean and healthy drinking water. With its exceptional performance and simple installation, this system is a must-have for any home or business.

Replacing E3-M Filter & Resetting the Meter

Follow these easy steps whenever you install a new filter cartridge.

1. Turn Off the Water

• Close the inlet and outlet valves on the bypass so no water flows into the system.

2. Remove the Cap

• Lift off the umbrella cap on the top of the system.

3. Replace the Batteries

• Install 3 fresh AAA batteries.
• We recommend changing the batteries every time you change your filter.

4. Reset the Meter

• Press and hold the reset button inside the cap for 3 seconds.
• The lights will flash green 3 times to confirm it has been reset.
• The system is now starting fresh at zero gallons.

5. Install the New Filter

• Remove the old cartridge and place the new one into the tank.
• Make sure it’s seated properly at the bottom connection.

6. Reassemble the Cap

• Put the top cap back on and lock the snap ring into place.

7. Turn the Water Back On

• Slowly open the bypass valves.
• Push down the red pressure relief button on the top until all air is released and water comes out.

8. Flush the Filter

• Run water through the system for at least 10 minutes to flush and activate the new cartridge.

9. Check the Lights

• During flushing, the green LEDs should blink when water is flowing.
• Green = filter is good.
• Yellow = nearing replacement.
• Red = change filter now.

Manual